Ok....For those having problems with Ethernet after this firmware update - I was able to fix mine.
Not sure what did it, but I re-flashed it, this time doing 2 things differently:
- When the flashing process was done (bar turned green and reported 100%), I pressed the big "STOP" button. The first time I flashed, I did not do this. I just assumed when it got to 100% and said success, it was done, and I unplugged the power (and USB cable) and plugged the power cable back in and turned it on. This time I pressed "STOP" first and when that was done I only unplugged the power (not the USB) and then plugged power back in and turned it on.
- I also tried using the img file from the 2nd link this time. First time I used the img file from the first link.
Not sure which of these two things solved it, but I am guessing it is the first (img files should both be the same one would hope?). Hope this helps someone else. The instructions PDF could definitely be a lot clearer regarding steps 6 and 7.
Hi JeffJacober,
I'm betting it's the second situation, because as you, I'm also had the same doubts and I've managed to to do the process twice with the same results.