Industrial X68 Auto Power on

Status
Not open for further replies.

RobHau

New member
Hi guys
At work, we use some MINIX NEO X68.
After each power loss, I have to manually press the power-on button.
Is there a solution for some auto power on?
I´m a greenhorn about MINIX, just use this Andriod for digital signage.
Thanks a lot.
Best regards
Robert
 
Good day RobHau, welcome to the forum.

Unfortunately this is an industrial unit used for signage, you will need to contact support@minix.com.hk as industrial units are not supported on this consumer forum.
 
Hi guys
At work, we use some MINIX NEO X68.
After each power loss, I have to manually press the power-on button.
Is there a solution for some auto power on?
I´m a greenhorn about MINIX, just use this Andriod for digital signage.
Thanks a lot.
Best regards
Robert
You can enable auto power-on by following below instructions:

Go to 'Settings' > 'Device' > 'MCU Settings' > 'Enable auto start system when plug in'.
 
Status
Not open for further replies.
Back
Top