Put U22 in Sleep with Logitech Harmony One remote [SOLVED]

[dnasini]

Hi
I just migrate from U1 to U22. I worked out how to "migrate" my previous Logitech Harmony profile to work with U22. One of things that are not working as before is the "power off". With the U1, pressing the Off button on the remote will shutdown all equipment of the Activity and put the U1 in Sleep mode. Next time I select the activity on the remote, it just pull out minix from the sleep mode and I'm displayed with the last menu screen where I was last time.
With U22, with same U1 Harmony profile, pressing the Off button will Power Off the minix, this means that at the next selection of the Harmony Activity, I'm displayed with the power up menu (minix logo, home screen,...)

Is there any setting on U22 or Harmony to put minix in Sleep instead of Power Off state sending the off remote command?

 

[dnasini]

Hi
I finally found a solution (or at least I hope so). Making some tests with an RF remote on my old Minix U1, I found that device behaviour changes depending on a long or short press of the power button. In particular

- Long press put the minix in power off
- Short press put the minix in standby

So I went into the Harmony software and changed the Power Off activity to "simulate" a short press. By default the signal is configured to send a "press" of the power off button of 1 sec, so I decreased this time to 0 sec and that's all

Hope this can help

 

[notrui]

- Long press put the minix in power off
- Short press put the minix in standby

You also can set that in a different way.
Go to your device settings and change as you want (sleep now, shutdown or restart) (powerkey definition).

You also can set your device to sleep after xxx minutes.