Rx-A860 receiver not compatible? CEC?

ender1962

New member
Can't figure this out. Last two Minix devices I've tried (and I've had many) don't seem to get along with my Yamaha aventage Rx-A860.
After a few seconds, in this case the Neo T5, my receiver seems to reset my tcl tv to it's home screen.
Series of events: turn on t5, which is plugged into HDMI 2 on my receiver. Receiver is then into HDMI 3 (ARC) on my 55 inch TCL. Navigate a but with the remote, TV resets itself to home screen. Receiver is still set to HDMI 2. Sometime u get more navigation time, sometimes less, but average is around 30 seconds.
Any ideas? Thanks.
 
Can't figure this out. Last two Minix devices I've tried (and I've had many) don't seem to get along with my Yamaha aventage Rx-A860.
After a few seconds, in this case the Neo T5, my receiver seems to reset my tcl tv to it's home screen.
Series of events: turn on t5, which is plugged into HDMI 2 on my receiver. Receiver is then into HDMI 3 (ARC) on my 55 inch TCL. Navigate a but with the remote, TV resets itself to home screen. Receiver is still set to HDMI 2. Sometime u get more navigation time, sometimes less, but average is around 30 seconds.
Any ideas? Thanks.
strange one but have you tried just temporarily attaching the T5 direct to the TV in another HDMI port to see if it happens there. That may give some clues.
Also you could try turning off as many "CEC" features as you can
 
Can't figure this out. Last two Minix devices I've tried (and I've had many) don't seem to get along with my Yamaha aventage Rx-A860.
After a few seconds, in this case the Neo T5, my receiver seems to reset my tcl tv to it's home screen.
Series of events: turn on t5, which is plugged into HDMI 2 on my receiver. Receiver is then into HDMI 3 (ARC) on my 55 inch TCL. Navigate a but with the remote, TV resets itself to home screen. Receiver is still set to HDMI 2. Sometime u get more navigation time, sometimes less, but average is around 30 seconds.
Any ideas? Thanks.

strange one but have you tried just temporarily attaching the T5 direct to the TV in another HDMI port to see if it happens there. That may give some clues.
Also you could try turning off as many "CEC" features as you can

Additionally......

Is the firmware on your T5 definitely up to date, & your TV & AVR too for that matter?

Navigate with which remote? The T5's remote or the TV's remote? (If you're using a single remote with CEC enabled to control both devices, have you also tried using both remotes again to see if this issue continues?)
 
Back
Top