MINIX - Martin
Staff member
Re-pairing
Recalibrating Sensors
Activate Fly Mode
Microphone Input Function
Keyboard Combos
More information can be found in the attached PDF manual.
Code:
1. Power up your Minix box.
2. Remove the dongle.
3. Remove one of the batteries from the controller.
4. Reinsert the battery and the red LED will flash 3 times.
5. Press and hold the Fn + P for a couple of seconds until the red LED illuminates steadily.
6. Reinsert the dongle whilst the red LED is illuminated.
7. Within 10 seconds the LED should extinguish and then flash 3 times.
8. Check the controller and dongle function correctly. If not, repeat the above steps carefully.
Recalibrating Sensors
Code:
1. Press Fn + Y on the keyboard.
2. Fn LED & operating status LED will glow.
3. Leave the remote on a flat surface for a few seconds.
4. LEDs will flash 4 times when successfully calibrated.
Activate Fly Mode
Code:
- Toggle the on/off switch to activate fly mode.
- Turning to the keyboard side will automatically disable fly mode.
- Tuning back to the front side, the previous mode will be resumed.
Microphone Input Function
Code:
1. Tap on the microphone icon inside an app if the microphone doesn't activate automatically.
2. Microphone status LED will glow when it's in use.
3. Press and hold the microphone button for 5 seconds to turn the microphone off.
4. For voice recording software, press and hold the microphone button on record voice.
Keyboard Combos
Code:
- Press Fn to switch between white and orange characters.
- Press Fn + Shift to use the bottom row orange characters.
More information can be found in the attached PDF manual.